Covering Eltham and nearby
We do not keep premises in Eltham. Instead, enquiries about frameless glass automatic doors come to us, we agree the price in writing, and a specialist engineer working under our management travels to the address in the SE9 postcode district on a date that suits the site.
Mixed-use blocks in Eltham, with shops or offices at ground level and flats above, often have communal entrances run by a managing agent. Doors there have to suit residents, deliveries and visitors, and approval from the freeholder or agent usually comes before work starts.
Nearby towns we also list for frameless glass automatic doors (straight-line distance): Welling (2.5 miles), Sidcup (2.8 miles), Woolwich (2.8 miles), Lewisham (2.9 miles), Catford (3.2 miles), Greenwich (3.3 miles).
What to think about for frameless glass automatic doors in Eltham
- Cleaning staff at busy venues in Eltham should use non-abrasive products on frameless doors, keep the floor guide clear of grit and report any chipped glass edge straight away.
- Glass partitions in office buildings across Greater London are often supplied by a fit-out contractor. Share their drawings with us so the door glass, gaps and finishes match the rest of the screens.
- Street-facing doors in Eltham that take the full force of wind and rain may be better as framed sliding doors. Frameless leaves have small gaps that let draughts and noise through.
- Every edge and fitting on a frameless door is visible. Choose a top rail and clamp finish, such as satin stainless or black, that suits the rest of the ironmongery in the building.
- Listed interiors and heritage buildings in Eltham sometimes favour frameless glass because it hides less of the original fabric. Consent may still be needed, so check with the planning authority early.
Frameless glass automatic doors in Eltham: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £5,495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Single-slide frameless glass door | £5,495 – £8,995 | installed, ex VAT |
| Bi-parting frameless glass door, about 2 m clear opening | £7,495 – £12,995 | installed, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
Standards and rules in England
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Eltham.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Use the guide price tool for an early figure, then let us survey your showroom, studio or reception in Eltham.
Frameless glass automatic doors in Eltham: questions
What should we do if the frameless door in Eltham is damaged?
If the glass is chipped or cracked, switch the door off, keep people away from the damaged leaf and contact us. A repair or replacement visit is priced in writing before an engineer attends, and replacement glass is quoted before it is ordered. Laminated glass usually stays in place until it can be replaced.
What will frameless glass automatic doors in Eltham cost?
Our guide starts from £5,495 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Eltham confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Is the survey for a frameless door in Eltham free?
Yes. For a new frameless automatic door, the survey is free and you are under no obligation. The engineer measures the opening, checks the structure above and the floor below, discusses glass and fittings, and you then receive a drawing and a fixed, itemised written quote.
Can a frameless door in Eltham match our existing glass partitions?
Usually, yes. We can match glass type and thickness, gap sizes and fitting finishes to the partition, working from the fit-out drawings where you have them. The survey checks the partition head and tolerances, so the new door sits in line with the existing glass and the operator is fixed to something solid above.
What should I send before the survey in Eltham?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for frameless glass automatic doors together more easily.
How much disruption should we expect while the work is done in Eltham?
Most installations take one visit or a short series of visits, with dust and noise kept to the area around the door. The engineer screens off the work area, keeps a route in or out where possible and clears up before leaving. Larger entrances, lobbies or structural changes take longer, and the quote explains how that work is phased.
Who is responsible for automatic doors on escape routes in Eltham?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.