Covering Dunstable and nearby
Engineers working under our management travel to addresses across the LU6 postcode district for fire door hold-open devices. There is no depot or showroom in Dunstable; you arrange everything with us by phone, email or the form on this page, and we confirm the price in writing first.
Town-centre buildings in Dunstable range from modern units to older shopfronts. Older frontages can have uneven floors, limited head height and timber frames that need checking before an operator is fitted or adjusted, and the engineer looks at these on site.
Nearby towns we also list for fire door hold-open devices (straight-line distance): Luton (4.5 miles), Leighton Buzzard (6.2 miles), Harpenden (8.5 miles), Berkhamsted (8.8 miles), Hemel Hempstead (9.6 miles), Hitchin (11.0 miles).
What to think about for fire door hold-open devices in Dunstable
- Hard-wired magnets need a power supply near each door. In buildings in Dunstable where that is awkward, battery units avoid running new cables along finished corridors.
- Listed buildings and conservation areas can make new cable runs difficult. Radio-triggered battery units avoid most wiring, although the transmitter still needs a connection at the alarm panel.
- Busy office corridors suit wall magnets that hold doors right back against the wall, out of the way of people and trolleys, until the alarm releases them.
- Doors that open too far from a wall for a wall magnet can use a floor-mounted unit or a magnet on an extension arm. The survey measures where each door rests when open.
- Background noise matters for acoustic units. Kitchens, plant areas and busy receptions may be too loud for a unit that listens for the alarm, so a wired or radio device is often better there.
Fire door hold-open devices in Dunstable: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £145 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Battery acoustic hold-open unit | £145 – £295 | per door, fitted, ex VAT |
| Hard-wired hold-open magnet linked to the fire alarm | £245 – £595 | per door, ex VAT; alarm panel work extra |
| Free-swing door closer linked to the fire alarm | £395 – £895 | per door, fitted, ex VAT |
Which hold-open device is suitable depends on your fire risk assessment. Linking to the fire alarm may need work by your alarm engineer.
Standards and rules in England
Hold-open devices and door release units linked to the fire alarm need regular testing as part of the building’s fire safety checks, and the results should be recorded.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for fire door hold-open devices and book a survey in Dunstable.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Ready to stop wedging fire doors open in Dunstable? Book a free survey and get a fixed, itemised quote for every door that needs a hold-open device.
Fire door hold-open devices in Dunstable: questions
Which doors in my building in Dunstable can be held open?
That is decided by the fire risk assessment for the building, not by the installer. Many corridor, lounge and office doors can be held open on a device that releases on the alarm, while some stair and escape route doors cannot. If the assessment is unclear, check with your assessor before we finalise the quote.
What is the guide price for fire door hold-open devices in Dunstable?
Our guide starts from £145 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Dunstable confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Are battery hold-open units a good choice for older buildings in Dunstable?
Often they are. Radio and acoustic battery units avoid long cable runs, which helps in older or listed buildings and finished corridors. Acoustic units are only suitable where the fire risk assessment allows them and the alarm can be heard clearly at the door. Batteries need replacing at the interval the maker states.
Do you fit fire door hold-open devices in Dunstable?
Yes. We arrange surveys and installations in Dunstable through specialist engineers working under our management. They look at each door, its closer and the alarm system, recommend a device for each door and we send a fixed, itemised quote. The survey costs you nothing, and you are under no obligation to accept the quote.
Can installation in Dunstable happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
What is the lead time for fire door hold-open devices in Dunstable?
Lead times depend on the door type and what has to be made to order. As a guide, operators and accessible door kits are typically two to four weeks from order, and complete sliding entrances typically four to eight weeks from drawing approval. Curved, revolving and hermetic doors usually take longer. The expected lead time is stated in your quote.
Do businesses in Dunstable have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.