Covering Edmonton and nearby
Homes, businesses and public buildings throughout the N9 and N18 postcode districts can arrange automating an existing door with us. We are the contracting party and organise every visit; the engineer, who works under our management, travels in to Edmonton for the job rather than working from premises in town.
Getting a van close to the door is often the hardest part of a London job. Red routes, controlled parking zones and loading rules vary from street to street, so access and parking restrictions are planned into the visit to Edmonton before it is booked.
Nearby towns we also list for automating an existing door (straight-line distance): Tottenham (1.6 miles), Enfield (2.1 miles), Chingford (2.5 miles), Walthamstow (2.9 miles), Wood Green (3.1 miles), Waltham Abbey (4.8 miles).
What to think about for automating an existing door in Edmonton
- Find out whether the door is a fire door. If it is, the operator must suit fire doors and be wired so the door closes when the alarm sounds.
- Power is needed at the head of the door. If there is no supply close by, an electrician will need to run one, ideally hidden in trunking or the wall.
- If the door is on an escape route, keep the existing panic or emergency hardware working. The operator should not stop the door opening by hand in an emergency.
- Shop fronts on high streets in Edmonton often have narrow aluminium frames. The survey checks the transom can carry the operator without flexing, and whether it needs reinforcing.
- Older buildings in Edmonton often have heavy timber doors on floor springs. Some floor springs can be adapted, but many need replacing with hinges, which adds to the cost.
Automating an existing door in Edmonton: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £1,795 ex VAT (£2,154 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Low-energy operator on an existing swing door | £1,795 – £2,995 | installed, ex VAT; homes £2,154 – £3,594 inc VAT |
| Full-energy operator on an existing swing door, with safety sensors | £2,495 – £3,995 | installed, ex VAT; homes £2,994 – £4,794 inc VAT |
| Operators on an existing pair of swing doors | £3,795 – £6,495 | installed, ex VAT; homes £4,554 – £7,794 inc VAT |
| Automating an existing manual sliding door or screen | £2,995 – £5,495 | installed, ex VAT; homes £3,594 – £6,594 inc VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. Fitting an automatic door helps, but does not on its own guarantee those duties are met.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for automating an existing door and book a survey in Edmonton.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Ask us to look at the doors at your premises in Edmonton. If a retrofit makes sense, you get a fixed quote, and if replacement is better, we explain why.
Automating an existing door in Edmonton: questions
How long will our door in Edmonton be out of use?
Usually half a day to a day per door. Where hinges, locks or glass are being changed as well, it can take longer. We plan the work so the building stays usable, and agree any out-of-hours working in the quote.
What price range should I expect for automating an existing door in Edmonton?
Our guide starts from £1,795 excluding VAT (per door), the same guide price we use across the UK. For homes that is from £2,154 including VAT. The free site survey in Edmonton confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Will automating our door in Edmonton need planning permission?
Fitting an operator to an existing door does not usually need planning permission, but a listed building may need consent for fixings or new switches on the outside. In a conservation area, mounting the operator inside often avoids any change to the street view. Check with the planning authority if in doubt.
Can you look after the door in Edmonton once it is automated?
Yes. We can arrange servicing at intervals that suit how much the door is used, with the operator, safety devices and hinges checked and a written record left. Each visit has its price confirmed in writing before an engineer attends.
Do you service doors in Edmonton after installing them?
Yes. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Servicing can follow on from the installation, with the price agreed in writing and a record left after every visit.
What should I send before the survey in Edmonton?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for automating an existing door together more easily.
Do businesses in Edmonton have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.