Coverage across Norfolk
We treat Norfolk as one service area for break-out escape route doors, so a site on the edge of the area gets the same written pricing and the same standard of work as one in the busiest town centre. Specialist automatic door engineers working under our management carry out each visit. Choose from the 7 towns below, or contact us with any address.
Towns listed in Norfolk: Norwich, Great Yarmouth, King's Lynn, Thetford, Dereham, Gorleston-on-Sea, Wymondham.
What to think about for break-out escape route doors in Norfolk
- If a canopy, ramp or steps sit close to the door, measure how far a broken-out leaf will travel. A leaf that clips a handrail or step edge will not give the escape width the strategy assumes.
- Listed buildings and conservation areas in Norfolk may need consent before a new entrance goes in. Slim frames and the existing opening can often be kept, but check with the planning authority before ordering.
- Work on a busy entrance in Norfolk is often best done early in the morning, in the evening or over a weekend. Any out-of-hours working is agreed and priced in the written quote rather than added later.
- A break-out door needs a dedicated fused spur and, where the strategy relies on it opening without mains power, a battery unit. If there is no supply near the head of the door, an electrician will need to run one.
- Get hold of the fire strategy, or ask your fire risk assessor, before the survey. Knowing whether the door must slide open on alarm, break out, or both, saves a second visit and a revised quote.
Break-out escape route doors in Norfolk: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £7,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Break-out sliding door set for an escape route | from £7,995 | installed, ex VAT; typically up to £16,995 |
| Converting an existing sliding door to break-out | Priced on survey | depends on the frame, leaves and operator |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
Standards and rules in England
In England, fire safety law says sliding or revolving doors must not be used for exits specifically intended as emergency exits. Break-out sliding doors are used where an entrance also forms part of an escape route, as the fire strategy allows. Whether a break-out door is suitable is decided by the fire strategy for the building and the responsible person under the Regulatory Reform (Fire Safety) Order 2005.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Norfolk.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Get a fixed price for a break-out sliding entrance in Norfolk. Use the quote form or call us, and we will arrange a survey at a time that suits the building.
Break-out escape route doors in Norfolk: questions
Our shop in Norfolk is inside a shopping centre. Can you still fit a break-out door?
In most cases, yes. Centre management usually sets rules on contractors, working hours and connections to the centre's fire alarm. We work within those rules, provide the method statements and insurance details they ask for, and plan the fitting so the unit can trade for as much of the time as possible.
What will break-out escape route doors in Norfolk cost?
Our guide starts from £7,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Norfolk confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Is a break-out door suitable for an exposed entrance in Norfolk?
Usually, yes. Wind pressure on the leaves is one of the things the survey checks, along with which way the entrance faces and how sheltered it is. The break-out fittings and operator settings are chosen so the leaves hold in line in normal weather but still open by hand in an emergency.
Do you install break-out sliding doors in Norfolk?
Yes. We arrange surveys and installations in Norfolk through specialist automatic door engineers working under our management. We supply the complete entrance, set it up to the fire strategy you give us, test it in every mode and hand over the records. The survey is free and the quote is fixed.
What should I send before the survey in Norfolk?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for break-out escape route doors together more easily.
Do I need permission from a landlord or the council before work in Norfolk?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
Do businesses in Norfolk have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.