Coverage across the Bristol area
Here is how coverage works in the Bristol area. You contact us with the address and what the door needs, we confirm the price in writing, and a specialist engineer working under our management attends on an agreed date. That applies to break-out escape route doors at a single shop door or across a whole estate of buildings, in any of the towns below or between them.
Towns listed in the Bristol area: Bristol, Fishponds, Bedminster, Clifton.
What to think about for break-out escape route doors in the Bristol area
- Older entrances on high streets in the Bristol area may have uneven thresholds or sloping pavements. Break-out leaves need a level floor and solid fixing for the bottom pivots, and correcting that can add a day to the work.
- If a canopy, ramp or steps sit close to the door, measure how far a broken-out leaf will travel. A leaf that clips a handrail or step edge will not give the escape width the strategy assumes.
- Hospitals and clinics in the Bristol area often want break-out entrances tied into the building management and fire alarm systems. Allow time for the alarm contractor to provide a signal and for the estates team to approve the interface.
- Listed buildings and conservation areas in the Bristol area may need consent before a new entrance goes in. Slim frames and the existing opening can often be kept, but check with the planning authority before ordering.
- Shopping centre units in the Bristol area usually need landlord approval for a new entrance and for any fire alarm connection. Ask centre management for their fit-out rules early, as they often set working hours and contractor requirements.
Break-out escape route doors in the Bristol area: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £7,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Break-out sliding door set for an escape route | from £7,995 | installed, ex VAT; typically up to £16,995 |
| Converting an existing sliding door to break-out | Priced on survey | depends on the frame, leaves and operator |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
Standards and rules in England
In England, fire safety law says sliding or revolving doors must not be used for exits specifically intended as emergency exits. Break-out sliding doors are used where an entrance also forms part of an escape route, as the fire strategy allows. Whether a break-out door is suitable is decided by the fire strategy for the building and the responsible person under the Regulatory Reform (Fire Safety) Order 2005.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in the Bristol area.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Ready to replace a sliding entrance in the Bristol area with one that breaks out? Book a free site survey and receive a written quote with the door, safety devices and lead time set out.
Break-out escape route doors in the Bristol area: questions
Our shop in the Bristol area is inside a shopping centre. Can you still fit a break-out door?
In most cases, yes. Centre management usually sets rules on contractors, working hours and connections to the centre's fire alarm. We work within those rules, provide the method statements and insurance details they ask for, and plan the fitting so the unit can trade for as much of the time as possible.
How are prices worked out for break-out escape route doors in the Bristol area?
Our guide starts from £7,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in the Bristol area confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you install break-out sliding doors in the Bristol area?
Yes. We arrange surveys and installations in the Bristol area through specialist automatic door engineers working under our management. We supply the complete entrance, set it up to the fire strategy you give us, test it in every mode and hand over the records. The survey is free and the quote is fixed.
Can you work with our fire risk assessor in the Bristol area?
Yes, and it usually helps. We can send your assessor the proposed specification, the break-out arrangement and how the door will behave on power loss and alarm, so they can confirm it matches the fire strategy before you order. Any changes they ask for are reflected in a revised quote.
What happens to the old door when a new one is fitted in the Bristol area?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
Do I need permission from a landlord or the council before work in the Bristol area?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
Which building regulations apply to a new automatic entrance in the Bristol area?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.