Covering Gateshead and nearby
If your building is in Gateshead, or anywhere in the NE8, NE9, NE10 and NE11 postcode districts, we can arrange automatic internal doors. Visits are booked with you in advance, timed around opening hours where that matters, and carried out by engineers who work under our management.
Care homes and supported living schemes are spread across Gateshead and the surrounding area, and their doors have to balance easy access with resident safety. Slow, gentle operation, hold-open devices linked to the fire alarm and controlled exits are typical requirements.
Nearby towns we also list for automatic internal doors (straight-line distance): Newcastle upon Tyne (0.9 miles), Wallsend (3.4 miles), Hebburn (3.5 miles), Jarrow (4.8 miles), Washington (5.5 miles), North Shields (7.1 miles).
What to think about for automatic internal doors in Gateshead
- Lightweight stud partitions may not carry an operator without extra support. The survey checks what the wall is made of and what reinforcement is needed.
- Doors linked to the fire alarm need a signal from the alarm panel. Allow time for your fire alarm contractor to provide the connection and test it with us.
- Measure what passes through the door, not just the door. Beds, hoists, trolleys and catering equipment can need a wider opening than the current door gives.
- Care homes in Gateshead often have residents with dementia. Think about which doors should open freely and which should be controlled, and agree that as a care decision before choosing controls.
- Plan the work around the building's routine. Clinical areas, classrooms and kitchens in Gateshead may need out-of-hours working, which should be agreed and priced up front.
Automatic internal doors in Gateshead: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £1,795 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Swing operator on an existing internal door | £1,795 – £3,995 | low-energy or full-energy, installed, ex VAT |
| Operators on a pair of cross-corridor doors | £3,795 – £6,495 | installed, ex VAT |
| Internal single-slide automatic door set | £4,495 – £7,995 | installed, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Gateshead and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on automatic internal doors separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Book a free survey of the internal doors at your building in Gateshead, and we will send a fixed, itemised quote door by door.
Automatic internal doors in Gateshead: questions
Can you service the internal doors in Gateshead after fitting?
Yes. We can arrange planned servicing with each door's operator, sensors and fire alarm release checked and a written record left. Servicing is chargeable, and the price per visit is agreed in writing before an engineer attends. Visits can be grouped so several doors are done together.
Is there a guide price for automatic internal doors in Gateshead?
Our guide starts from £1,795 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Gateshead confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you work in hospitals in Gateshead?
Yes. We work to the estates team's requirements for door widths, controls, infection control and fire alarm interfaces, and provide method statements, insurance details and the documents they ask for. Work on wards is usually planned out of hours or in phases.
Can you fit automatic doors in a school in Gateshead?
Yes. Corridor fire doors, dining halls and doors to accessible facilities are common. We usually plan the work for school holidays or after hours, and agree the programme with the school in writing so safeguarding and fire arrangements are maintained throughout.
How are payments structured for work in Gateshead?
Payment stages are set out in the quote before you accept it. Larger or made-to-order jobs may involve a deposit and a balance on completion, while smaller jobs may be invoiced once the work is finished. Nothing is charged for the survey itself, and the terms you accept are the terms that apply.
Will the building stay secure while the entrance is being changed?
We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in Gateshead is agreed before work starts.
Which building regulations apply to a new automatic entrance in Gateshead?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.