Covering Hammersmith and nearby
From shops and surgeries to schools, care homes and private houses, any building in the W6 and W14 postcode districts can be covered for automatic door refurbishment. Specialist engineers working under our management carry out the work, and you deal with us as the contracting party from start to finish.
Getting a van close to the door is often the hardest part of a London job. Red routes, controlled parking zones and loading rules vary from street to street, so access and parking restrictions are planned into the visit to Hammersmith before it is booked.
Nearby towns we also list for automatic door refurbishment (straight-line distance): Shepherd's Bush (0.8 miles), Chiswick (1.3 miles), Fulham (1.6 miles), Kensington (1.7 miles), Acton (2.3 miles), Putney (2.3 miles).
What to think about for automatic door refurbishment in Hammersmith
- Care settings in Hammersmith benefit from level thresholds and smooth-running leaves that do not snag walking frames, trolleys or wheelchair footplates as people pass through.
- Busy retail units in Hammersmith may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- Floors around the door in Hammersmith may be worn or uneven. New floor guides and thresholds sometimes need small areas of making good, which the quote lists separately.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
Automatic door refurbishment in Hammersmith: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Hammersmith.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Send us photos of the door that needs attention in Hammersmith, and we will arrange a survey at no cost and an itemised quote for the work.
Automatic door refurbishment in Hammersmith: questions
Can you replace a single broken glass leaf in Hammersmith?
Yes. The leaf is made safe, measured and reglazed with new safety glass, or replaced completely if its frame is damaged. New glass is typically 2 to 4 weeks from order. Once the leaf is rehung, the door is set up again and the track and floor guide are checked.
What do you charge for automatic door refurbishment in Hammersmith?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Hammersmith confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Is it worth refurbishing an old door at our premises in Hammersmith?
If the frame is sound and the opening size still works, usually yes, as refurbishment costs far less than a new door. If the frame is corroded, the glass is not safety glass or the opening is too narrow, a new door may be better value, and the survey tells you which.
Can you refinish the frame of our door in Hammersmith?
Yes. Aluminium frames can be cleaned, repaired and recoated on site to refresh their colour. Badly damaged sections may need replacing rather than refinishing. Refinishing is listed separately in the quote, so you can decide whether to include it now or leave it for a later phase.
Can installation in Hammersmith happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
What does the free site survey in Hammersmith involve?
An engineer working under our management visits the building, measures the opening, checks the frame, floor, head height and power supply, and looks at how people use the entrance. The survey is free and carries no obligation. Afterwards you receive a fixed, itemised written quote for automatic door refurbishment, with drawings where the door type needs them.
Which building regulations apply to a new automatic entrance in Hammersmith?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.