Automatic Doors in Wick

Automatic door work in Wick

Many buildings in Wick are older, with timber frames, thick walls, steps or uneven thresholds. These affect where an operator and sensors can go, and the engineer checks them on site before anything is fitted or adjusted.

Refurbishment. New glass, tracks, rollers, seals and floor guides to bring a tired automatic door back into good order, priced as a fixed, itemised quote after a free survey. See refurbishment.
Safety inspections. A documented check of each door's safety functions and a site-specific risk assessment with reference to BS EN 16005, for employers, landlords and building managers in Scotland. See safety inspections.
Access control and activation. Card readers, keypads, timers, push pads and touch-free switches tied into the door operator, so the entrance opens for the right people at the right times. See access control.
Fire door hold-open devices. Alarm-linked devices that keep busy fire doors open for everyday use and release them to close automatically when the fire alarm operates. See fire door hold-open devices.

Services in Wick

New automatic doors

Accessibility and control

Repairs, servicing and safety

Automatic doors and the law in Scotland

Scottish building standards guidance (the non-domestic Technical Handbook) expects an accessible entrance door to give a clear opening of at least 800 mm, says powered doors improve accessibility as long as they add no new hazard, and expects signage, sensors that hold the door open long enough, and guarding against collision or entrapment.

Doors on escape routes and fire doors are covered by the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006. In Scotland, fire safety regulations say sliding or revolving doors must not be used for exits specifically intended as emergency exits, and Scottish guidance allows automatic and revolving doors on an escape route only where they fail safely to outward opening, or have a monitored fail-safe system that opens them on power failure, sensor failure and fire alarm.

Nearby towns (straight-line distance)

Thurso · 18.9 mi

Questions from Wick

Is the site survey in Wick free?

For new automatic doors, upgrades, retrofits and home door openers, yes: the site survey is free and comes with a fixed, itemised written quote and no obligation. Repairs, servicing and safety inspections are different. For those, the visit price is agreed in writing before an engineer attends.

How long does an automatic door installation in Wick take?

Fitting an operator to an existing door often takes a day, and a complete sliding entrance typically takes one to three days on site once the door has been made. Lead times before that are typically two to eight weeks, depending on the door type. Your quote sets out the expected lead time and the time on site.

Can an existing door in Wick be made automatic?

Often, yes. If the door, frame and hinges are sound, a swing or sliding operator can be added rather than replacing the whole entrance. The free survey checks the weight and condition of the door, the fixings, the space for the operator and the power supply. See automating an existing door for what is involved.

How much do automatic doors cost in Wick?

Prices depend on the door type, the size of the opening and what is already there. We publish guide prices for every service on our prices page, and the guide price tool gives a range before anyone visits. The same guide prices apply across the UK, and the written quote confirms the figure for your building.

What information helps when I contact you about a door in Wick?

The address, the type of building, photos of the door from both sides and a rough size of the opening. For a fault, add what the door is doing and a photo of any label on the operator. For a new door, tell us how the entrance is used and by whom. That lets us book the right visit and agree the price in writing.